Tork Craft Polisher 1200W With 180Mm Wool Bonnet And 4M Cord

6 Months Warranty Included

Supplied With A 180Mm Wool Bonnet Buff And Backing Pad.

Application:

The Polisher Is A Power Tool Used In The Finishing Process, Used With Polishing Buffs And Compound Sponges To Yield A Dramatic Difference On A Painted Surface.

The Objective Of Polishing Is To Remove Imperfections In The Clear-Coat That Cause The Paint To Look Dull. Surface Imperfections Can Include Swirls, Scratches, Water Spots, Etchings, Industrial Fallout, Oxidation, Etc.

Features:

• Professionally Manufactured For The Automotive Paint Care And Detailing Industries.
• Ergonomically Designed To Reduce Fatigue In Long Term Use.
• The Polisher Has Various Hand-Held Positions To Better Hold The Polisher At Angles.
• Gear System Has A Two-Level Deduction. With Two Times The Amount Of Torque Than A Single Gear Set Polisher

Extra Information:

Steps To Take When Polishing A Panel:

1. Preparing The Panel:

• Sometimes A Panel Has Fine Over-Spray Left From Spraying The Clear-Coat. This Needs To Be Removed By Lightly Sanding With A Fine Abrasive Paper. All Over-Spray Need To Be Sanded Out Up To P1500 Grit.
• The Panel Should Be Washed When All Spray-Finishing Defects Have Been Removed. Any Dirt Particles Could Cause Scratch Marks When Polishing.
• Tight Curves And Ends Of The Panel Should Be Masked-Off To Prevent The Effects Caused By Point Pressure. The Polisher Should Always Be Used On Flat Surfaces.

2. Applying The Polishing Compound:

• A Five Rand Coin Amount Of Polishing Compound Should Be Applied To The Buff. Switch The Polisher To It’S Lowest Speed Setting.
• Switch On The Polisher And Gradually Spread The Polishing Compound Over The Panel.
• Keep Moving The Polisher On The Panel To Have As Little Amount Of Pressure And Friction.
• The Polishing Compound Will Remove The Scratch Marks Caused By The P1500 Sand Paper And It Will Bring Out An Impressive Gloss Finish.
• Remove The Masking From The Panels And Apply The Polishing Compound To A Microfiber Cloth. Hand Polish (By Moving Your Hand In A Small Circular Motion) The Tight Curves And Ends In The Panels Until The Same Finish Is Achieved As From The Polisher.

3. Wash The Panel When Finished:

• Wash The Panel After Polishing To Remove Any Residue From The Polishing Compound.

General Safety Suggestions:

It Is Advisable To Always Have The Following Items Nearby And In A Good Condition

• Eye Protection Clean And Scratch Free
• Hearing Protection Quality Earmuffs
• Dust Masks Discard Old And Dirty Masks
• Gloves For Easy Handling Of Material And Hand Protection