These are VERY limited. Once they are sold out, they are gone!

This unpainted resin armor is 10.25″ long, 3.5″ across.

Please read everything below carefully:

-You will receive a pair ( 2 identical pieces) of blank white wearable resin armor.

– The pics showing finished armor are just examples of what can be done. I strongly encourage buyers to add their own spin on these designs.

-Please do not purchase this item if you are unsure of what to do to finish it. I can not personally assist buyers with this project.

– These are RAW CASTS meaning they will need edge clean-up and air bubble filling. They are sent as is direct from the mold with no sanding or finishing.

FITTING:

A perfect fit is not guaranteed. You may have to expand the pieces for a better fit. You can do so using heat.

-Warm the plastic with a hair dryer or on VERY low temp in your home oven ( place on cookie sheet and on a supportive bowl or cookware so the mask does not warp under it’s own weight) You can also run it under hot water to soften the plastic.

– Only heat for around 5 minutes.

-Gently pull the sides apart while warm until you get the fit you want. Let the mask cool to set the shape.

– Once you get the shape you want you can reinforce the inside with a thin layer of Free-Form putty ( can be smoothed with water and a brush once applied) or other lightweight epoxy putty ( ask for wood filler putty at the hardware store)